> Service > Solutions > Install Jaw Crusher

Install Jaw Crusher

How To Install Jaw Crusher?

1, Should carefully examine whether there is a good lubricating bearings, bearing the connection, and whether there is sufficient oil.
2, Should be carefully examined all of the fastening is completely fixed.
3, the transmission belt is good, that there should be replaced with a logo, there is grease on the belt or pulley, a clean rag and wipe his application.
4, The protection device is good, and if found, the phenomenon of protection device is unsafe, shall immediately be canceled.
5, Check whether the ore crushing chamber, or other debris, such as minerals, or other debris should be removed.

1, The checks to prove that mechanical transmission part is normal, before the start.
2, The machine is started under load conditions only in the case of promises.
3, Starts, if found to have abnormalities, should immediately stop running, you must identify and eliminate non-normal, then re-start the crushing machine.

1,The normal jaw crusher operation, and then begin to feed stone.
2, Breaking the material should be uniform to join the crushing chamber, feeding should be avoided to prevent a sudden increase in load or unilateral mutations.
3, Under normal circumstances, the bearing temperature rise should not exceed 35 ℃, the maximum temperature rise does not exceed 70 ℃.
4, In use, Ruoyin crushing chamber materials, blockage caused by the parking should be immediately shut down the motor, material must be removed first Ti and then restart.

1,The regular and timely attention to the lubrication of friction surfaces, and then, in order to ensure the normal operation of crusher and prolong life.
2, The machine used in the calcium-based grease, users can also be used according to the location of the machine, temperature, and the choice of other types of oils and fats other conditions, but must be protected by a well-oiled bearings.
3, By adding 50-70% of the total bearing, oil, must be replaced every 3 months. Oil change, the application of clean gasoline and kerosene, and carefully clean ball bearing slides.
4, Elbow board, elbow pads plate in contact with the oil before the start of the crushing machine.

Discover your crusher and grinder machine at the discount!